Category: CCENT

LBSources

GNS3 Tutorials: BlindHog - How to build a switching lab Part 2

Written by LBSources from http://www.gns3-labs.com on July 29th, 2008 | 1 Comment

So Josh (BlindHog) came around with part 2 pretty quick.
As per the his blog
This is part two of my gns3 switching tutorial series. In part 1, you learned how to use a 16 port network module (NM-16ESW) to simulate many features of a Cisco switch. In this tutorial, you will learn how to configure vlans [...]

LBSources

GNS3 Tutorials: BlindHog - How to build a switching lab

Written by LBSources from http://www.gns3-labs.com on July 25th, 2008 | 0 Comments

In case you have had a look at our Topology: VLAN Trunking GNS3 Lab - 802.1Q - Router On A Stick & need some help with configurations have a look over at BlindHog.
As per BlindHog:
In this tutorial, you will learn how to build a Cisco switching lab … even though GNS3 cannot emulate a Cisco [...]

LBSources

Topology: GNS3 CCENT Lab From Jeremy @ CiscoBlog

Written by LBSources from http://www.gns3-labs.com on June 6th, 2008 | 8 Comments

This lab was created by Jeremy of CiscoBlog.com. This lab is more of an exercise and does NOT include the configs.
Routers Used: c2621
IOS: c2600-i-mz.123-26.bin
Feature of Topology:
1) Basic setup of all Cisco routers
2) Configure all Cisco routers for SSH support
3) Configure IP connectivity and RIP routing support for Cisco network
4) Configure SDM support on all [...]



Subscribe To GNS3-Labs

Subscribe to GNS3 Labs :: Cisco Router Simulator Network Topologies


Your Ad Here