BlindHog: Saving GNS3 Labs Including Router Configs
Written by LBSources from http://www.gns3-labs.com on July 8th, 2008 | 1 CommentWe have all experienced a time when working in GNS3 and we _think_ we saved the the topology and router configurations. So you open GNS3 and load that config, start them routers, watch them boot all the way to the painful promt
Would you like to enter the initial configuration dialog? [yes/no]:
And your hard work is GONE! 
Well my buddy Josh blogged about the 1st thing we should all do when starting a new lab.
GNS3 - How to save labs with router configs
1,050 viewsTags: BlindHog, GNS3, GNS3 Tips
You can leave a response, or trackback from your own site.
More from LBSources
- WordpressMobile Plugin - Visit GNS3-Labs From Your Mobile Device
- GNS3-Topology: CCNA & CCNP Full Mesh Topology Template
- GNS3 Topology: BSCI - EIGRP & ISIS Redistribution Lab
- VLAN Database Lost When Restarting? - Saving VLAN.dat To NVRam
- GNS3 Topology: Basic IPSec VPN Over Frame-Relay Lab
Subscribe to GNS3 Labs :: Cisco Router Simulator Network Topologies
July 31st, 2008 at 5:41 pm
no commentt